Rocking Chair Assembly Instructions

Tools Required:
1. Phillips Screwdriver
2. Flat Head Screwdriver
3. Rubber Mallet

Parts:
1. Chair Base
2. Rockers (2)
3. Chair Back
4. Support Struts (Rockers Only) (2)
5. Screws (4 long, 2 short)

Instructions:

1. Put Chair Base (1), opened, upside down on protected surface. Attach each Rocker (2),
   with flat end to front, by matching front two holes in Rocker to legs of Chair Base, and
   firmly tapping Rocker into place with rubber mallet.
2. Set Chair Base upright, folded half closed. Attach Chair Back (3) to Arms by matching
   each hole in Chair Back to peg at rear of Arm, and firmly tapping Chair Back into place
   with rubber mallet. Use 1 long Screw for each side and secure Chair Back to Arms but do
   NOT fully tighten. Then, use 1 long Screw for each side and secure Chair back to base,
   but do NOT fully tighten Once both sides are secured, fully tighten all 4 screws.
3. Insert a Support Strut (4) into a Rocker hole. Use one short Screw to secure Strut to Back
   of Chair. (NOTE: The Chair Back does not have a pilot hole for this Screw.
   So carefully screw Strut to Chair Back where Strut naturally fits.) Repeat on other side.
4. In Tall Chair models, swing down the Head Rest Strut into Support Screw — and Rock
   On!

To fold Chair for storage or to transport:
For Tall Chair models only: First, lift Head Rest Strut and swing it down.
For all other models: Pull sides of Leather Seat up and Chair will fold.

Care and Maintenance:

• For mahogany wood as needed use any quality furniture polish, furniture oil or
  revarnishing material.
• For leather, as needed clean with any type of leather balm, saddle soap, or oil.